[ Chinese wardrobe net ] the whole edge of the wardrobe knowledge Custom-made panel furniture should pay attention to the selection process, including cutting, punching and edge-sealing. The difference between the quality of the edge-sealing strips and their respective advantages and disadvantages will also be explained. some information. The typical edge sealing process is as follows: Spray anti-adhesive agent, edge milling, workpiece preheating, gluing, pressure sealing, edge band cutting, front and rear cutting, up and down roughing, up and down finishing, tracking repair, scraping repair, shovel layer, cloth wheel polishing , quality inspection. A good edge banding machine is formed in one process in the above process. The glue used is an environmentally-friendly hot melt adhesive, which is formed from the spray anti-adhesive agent to the rear cloth wheel polishing. Responsible furniture factories will also seal the four sides of the board, not just one or both sides that the consumer can see. About edge sealing and formaldehyde: I often hear the sales of panel furniture, or the whole furniture (ie, the whole wardrobe , the wall-mounted wardrobe, the custom furniture), how the sealing is good, how the bad edge-sealing process affects the formaldehyde content, etc. This introduction is not accurate enough and rigorous, because the plate is not enough environmental protection is related to the formaldehyde content, but it is not directly related to the edge sealing. Good sealing or multi-face sealing can only reduce the emission per unit time of formaldehyde (ie The emission rate is slowed down, and the formaldehyde content of the board is not reduced. The advantage of this is that the environmentally-friendly (such as E2 grade) sheet can be reduced to a level acceptable for human consumption without affecting health. Emergency Stretcher,Adjustable Patient Stretcher,Hospital Emergence Stretcher,Patient Emergency Trolley Jiangmen Jia Mei Medical Products Co.,Ltd. , https://www.jmmedicalsupplier.com
Overall wardrobe knowledge edge sealing process