There are a lot of people who operate around the horses. What kind of fault knowledge should you know when you are running a business? Here's a small editor of the company to tell you: The company's Sports Equipment Co., Ltd. warm reminder: Caring for children's healthy growth, starting from paying attention to children's safety! ningbo haonuo hardware factory , https://www.haonuocrafts.com
Fault one: the horse can not start 1. The test is not the electrical cabinet and line fault. Can not start first to check whether the electrical control cabinet is working, first check whether the power indicator of the electrical control cabinet is on, the indicator Light is on, indicating that the power input to the electrical control cabinet is no problem, the indicator light is not on. There is a problem of disconnection and short-circuit in the circuit where the power supply is connected to the control cabinet. If there is, reconnect or replace the circuit. If no problem, then open the electronic control cabinet to check whether the relay knife is closed, whether the fuse is broken, and if so, close and replace it. If the fault still exists, check whether the circuit board is connected to the conductive ring of the horse to see if there is a disconnection (the position of the conductive ring is in the middle column of the rotating horse), and if there is any disconnection between the conductive loop and the motor, if there is any, reconnect or replace it. line. Check whether the conductive ring and the carbon brush are in contact with dust and poor contact. If so, use a screwdriver to press it.
2. Check the motor again. If the electric control cabinet and the line are not faulty or the fault still cannot be started, it is necessary to check whether the motor is faulty, remove the belt on the motor pulley, start the power button on the electric control cabinet, and then see if the motor is working, if it is not working, The motor is damaged and needs to be replaced.
Fault II: difficult to start a horse 1. Bearing too tight problem. The occurrence of such failures generally occurs in the case of new trotting horses. Adjustable wrenches are available, moderate tension can be achieved, and lubricating oils can be added for better results.
2. The voltage is unstable or too low. Many devices have difficulty starting or cannot be started because the voltage is unstable or too low. This is mainly caused by excessive voltage load in the vicinity. This phenomenon is particularly evident in summer. The inspection method is to press the start button of the electric control cabinet to observe whether the voltmeter is normal. The solution is to replace the larger square of the power cord or replace the line access point. The most direct but not effective method is to press the start button of the electric control cabinet, and then find two people to push the market to see if it can work normally.
3. The problem of loose triangle belts. If the triangle belt is loose, you can adjust the distance between the motor and the pulley or replace it with a new one of the same type.
Fault 3: Shaking and excessive noise appearing on the horse 1. This is because the market is not running smoothly. Check the tire for leaks or insufficient air pressure. If there is a leak, replace it or repair it. If the air pressure is not enough, it can be applied to the tire. Inflate, usually three and a half pressure.
2. Because of the increase of the friction force of the transmission part and the bearing, add the lubricant.
Fault 4: Close the power switch, three-phase indicator light is not lit or not all light The above condition indicates that the indicator light of the turn indicator is broken. The solution is very simple, just replace the indicator or replace the fuse. Yes.
Fault 5: Press the light start button contactor to pull, but the light appears all the way or several roads are not bright If you turn around the horse to appear the above phenomenon, the fuse on the lighting control board is blown, which needs to replace the fuse of the same type. After the replacement, this problem was successfully resolved.
Turning horse operators to know what fault knowledge