Basic knowledge of cricket ground

Site introduction

In the cricket game, the cricket pitch has a three-column gate - 1 chain or 22 yards (20.12 meters) long and 10 feet (3 meters) wide between the central dividers. The surface is very flat, usually covered with short grass, but the grass on both ends of the court will be worn away in the game.

板球场地标准

Cricket Ground Standard

In amateur games, artificial fairways are often used. Some are concrete slabs, mats cover artificial turf, and sometimes the palm mats are covered with soil to provide realism to the course. Artificial pitches are rare in professional cricket matches and are only used in important exhibition matches in the region.

In the cricket rules it is stipulated that there is a very specific area line on the course as a marker.

The term tri-column often refers to the court. Although technically incorrect, according to the cricket rules (rule seven includes the difference between the court and the rule eighty-three columns), board players, followers, and commentators insist on using the ambiguity to eliminate any possible circumstances. The track is another synonym.

The rectangle in the center of the court - the space used by the court, is called the square.

三柱门示意图

Three-post door schematic

protected area

In the middle of the court is a protected or dangerous area - rectangular, two feet wide, 5 feet ahead of each pitch line. According to the cricket rules, the pitcher must avoid following up on passing the ball. If the pitcher runs in the protected area, the referee will warn the pitcher and the captain. If the pitcher fouls again, it is a second and final warning. For the third foul, the referee will make the pitcher out of the game so that he can't hit the ball again in the hitting.

This kind of protection in the protected area is to prevent the ball on the court from rebounding in this area. If the stadium is worn out or damaged, then the pitching party will have a deliberate foul and may be determined based on the footprint of the pitcher. This rule does not prevent the pitcher or any outfielder who is trying to defend in a protected area. It only applies to situations where the ball is followed up continuously.

National Stadium

Natural damp long grass fairways are described as green fairways. This helps the pitcher cross the batter because the ball becomes irregular on long grass or wet grass. Most clubs and community cricket grounds, professional cricket players call it green.

The damp three-column gate - the wetland course - caused the ball to move irregularly, especially the slower spinning ball. However, modern stadiums are generally rain-proof during the competition and are therefore not common in the first class competition. This sentence still maintains any difficult situation outside the current and cricket.

As the game progressed, the stadium dried up. The rules of the cricket dictate that the court should be sprinkled during the game. When it dries, it will be easier to hit the ball initially because there is no moisture. After four or five days of play, the stadium began to crack and then turned into debris and dust. Such courses are commonly known as 'dust storm zones' or 'minefields'. However, this is good for bowlers, especially for players who are good at throwing spins. They can get a lot of traction through the surface of the ball and make the ball spin for a long time.

When the status on the playing field changes and the game is one of the top strategic considerations, it is relatively difficult for the batters and the players. The team’s main players will decide on the coin, which will ultimately determine which team took the lead. ball.

Site coverage

The stadium needs protection. The administrator covers it to prevent rain. The use or non-use of coverings will obviously affect the ball's detachment from the stadium, and this issue may be controversial. Article 11 of the cricket rules shall not cover the venue completely during the match unless otherwise specified or passed prior to the agreement. If possible, keep the venue dry even if the player is playing in bad weather. If the site is covered overnight, the cover needs to be removed as soon as possible before the morning game. If it is only used for protection against bad weather or if it is to be removed at night in the event of such weather delays, the faster, the better, if possible. Machines used to remove excess water on or off the field are called suction machines.

competition rules

During the game, during the game, the captain of the batting party may request that the rotation time of the court before each game start shall not exceed 7 minutes (except for the first game of this game and the next few days before the start of the game). In addition, if the kick-off is delayed in the first game after the throw and before the game, the hitting party may request to rotate the ball for no more than seven minutes. Unless the referee unanimously agrees, the delay did not have a significant impact on the court's condition. Once the game starts, this type of throwing will not happen in this case. If more than one swing is available, the captain of the shot should have choice. There are detailed rules to make sure that the ball is thrown in a way that does not delay the game, but if necessary, the game is delayed and the team captain is allowed a 7 minute toss off time.

Typical course

The Australian Stadium has historically been called the best venue for quickball because it can generate rebounds from the ground. In particular, the Perth's Western Australian Cricket Association Stadium is considered to be probably the fastest track in the world. Brisbane Gaba is also known as a place to help pitchers quickly rebound. However, these kinds of elastic courses are also used to promote the development of more scoring runs such as pulling, hooking, and stealing. There are many examples of good examples of hitters hitting the ball on the court.

援格林纳达板球场

Grenada Cricket Ground

Watercolor Painting Brushes

Types of brushes.There are so many many brushes:washes/glazes, rounds, flats, filberts and liners and more. Choosing the right type for the technique is important. Let`s look at the different types.Flat Brushes:Flats are brushes with a straight chisel edge and square shaped filaments. These can be known as shades if they`re in smaller sizes and washes/glazes if in bigger sizes. Large areas are painted with a wash/glaze brush whereas smaller flats are used for small areas of painting. Round brushes-Round brushes have a large diameter of the ferrule, more so than a liner, which can be used for applying thick to thin lines, filling in odd shaped areas, painting details and work great for lettering. Liners don`t hold as much paint as a round, however, they are super great for creating lines or curves. Script liners are similar to liners but the filaments are much longer and hold more paint. A round brush tapers to a pointed tip – several types of rounds are referred to rounds, liners or script liners. Angle brushes are filaments that have been cut on an angle – these are excellent to use in small or curved areas of the painting.Filberts Brushes with oval shaped filaments are known as filberts in smaller sizes and oval wash in larger sizes. Both shapes can be used for base coating, stroke work and more. There are filbert combs, filbert wash and more. Mop Brushes:Then there are mop brushes–great for blending and smoothing out small areas. They`re also ideal for applying powdered pigments–just dust them lightly over hot or tacky wax.Specialty Brushes:Then there are all the speciality brushes on the market used for certain techniques and garner their own results–fan, deer-foot, stumbler, mops,stencil and more.
SAMINA FORAM OFFER various different shapes of Painting Brush like flat , slant, oval and filbert Brushes....

Painting Brush


Watercolor Painting Brushes,Painting Brushes,Watercolor Painting Brush,Watercolor Painting Art Brush

SAMINA FORAM (SHENZHEN) CO., LIMITED. , https://www.saminamakeuptools.com