1. Check whether the photoresist is enough. Generally, 1/4 in the tank is enough. If it is not enough, remake the photoresist. 2. Pour the photosensitive glue into the sizing device of the semi-automatic screen printing machine to 2/3 full, hold the middle point of the sizing device on both sides with your right hand to maintain balance; hold the upper frame and lower frame of the screen frame with your left hand and place it on a clean ground , The screen is at an angle of 45 degrees to the ground, and the glue is applied from bottom to top; the angle between the sizing device and the mesh cloth is 45 degrees; only from the bottom to the top, the uncoated part is sizing again, and there is photosensitive glue on all sides And very even. 3. Put the screen plate coated with photosensitive adhesive and the net cloth on the semi-automatic screen printing machine. After about 10 minutes, no water droplets can be seen on the mesh cloth; when there are no water droplets on the surrounding frame, the screen is already dry. You can apply the photoresist a second time. After drying, you can print. brush Puyang Maikefu Commodity Co., LTD , https://www.maikefufoam.com
How to apply photosensitive glue to semi-automatic screen printing machine