What may happen to children's play equipment?

Occasionally there will be unexpected situations in the operation of indoor amusement equipment. Let Xiao Bian tell you what happened in the business.

One, can not start

1. The control cabinet and the line are faulty. Can not start first to check whether the electrical control cabinet is working, first check whether the power indicator of the electrical control cabinet is on, the indicator light is on, indicating that the power input to the electrical control cabinet is no problem, the indicator light is not on. There is a problem of disconnection and short-circuit in the circuit where the power supply is connected to the control cabinet. If there is, reconnect or replace the circuit. If no problem, then open the electronic control cabinet to check whether the relay knife is closed, whether the fuse is broken, and if so, close and replace it. If the fault still exists, check whether the circuit board is connected to the conductive ring of the horse to see if there is a disconnection (the position of the conductive ring is in the middle column of the rotating horse), and if there is any disconnection between the conductive loop and the motor, if there is any, reconnect or replace it. line. Check whether the conductive ring and the carbon brush are in contact with dust and poor contact. If so, use a screwdriver to press it.

2. Motor failure. If the electric control cabinet and the line are not faulty or the fault still cannot be started, it is necessary to check whether the motor is faulty, remove the belt on the motor pulley, start the power button on the electric control cabinet, and then see if the motor is working, if it is not working, The motor is damaged and needs to be replaced.

Second, difficult to start

1. The bearing is too tight. The occurrence of such failures generally occurs in the case of new trotting horses. Adjustable wrenches are available, moderate tension can be achieved, and lubricating oils can be added for better results.

2. The voltage is unstable or too low. Many indoor children's play equipment is difficult to start or cannot be started because of unstable or excessive voltage, which is mainly caused by excessive voltage load in the vicinity. This phenomenon is particularly evident in summer. The inspection method is to press the start button of the electric control cabinet to observe whether the voltmeter is normal. The solution is to replace the larger square of the power cord or replace the line access point. The most direct but not effective method is to press the start button of the electric control cabinet, and then find two people to push the market to see if it can work normally.

3. The triangle belt is loose. If the triangle belt is loose, you can adjust the distance between the motor and the pulley or replace it with a new one of the same type.

Third, the jitter and noise is too large

The problem of excessive jitter and noise is due to the unstable operation of the market. You can inspect the tire for leaks or insufficient air pressure. If there is a leak, replace it or repair it. If the pressure is insufficient, you can inflate the tire. Three and a half pressure can be. The second reason is that due to the increase of the friction force of the transmission part and the bearing, the lubricant can be added.