How to connect the computer socket? With the advancement of society, the development of the economy, the development of the Internet, and the improvement of people's living standards, almost every company and even many families are using computers. The role of computers is many. Computers can be used for entertainment and learning. A lot of convenience. So, how to connect the computer socket? Let me introduce you here, people who don’t know can understand. Step 1: Use the oblique length to cut the length of the twisted pair required, at least 0.6 meters, and no more than 100 meters. Then use a twisted pair wire stripper to remove the outer skin of the twisted pair 2-3 cm. Step 2: Perform the operation of dialing. Move the orange diagonal line in the bare twisted pair to the front of the line, the brown line to the direction of the line, the green line to the left, and the blue line to the right. Step 3: Place the green line and the blue line in the middle, while the orange line and the brown line remain in place, that is, placed outside. Adjust the line order to (left one: orange left two: blue left three: green left four: brown) Step 4: Carefully strip each pair of wires with the white blending line facing forward. It is important to note that the green line should span the blue to the line. The most common place to make mistakes here is to put the white-green line adjacent to the green line, which will cause crosstalk and reduce transmission efficiency. From left: White Orange/Orange/White Green/Blue/White Blue/Green/White Brown/Brown The common mistake is to place the green line on the 4th foot. Step 5: Cut the bare twisted pair with scissors or diagonal pliers and leave only about 14 mm in length. Finally, each wire of the twisted pair is placed in the pin of the RJ-45 connector in sequence, and the first pin should be placed in a white-orange line. Step 6: After each wire of the twisted pair has been correctly placed, the RJ-45 connector can be crimped with an RJ-45 crimping tool. Step 7: Repeat steps 2 through 6 to make the RJ-45 connector on the other end. Step 8: Test with a network cable tester. How to connect the computer socket? The above is the relevant content. It is best to ask a master to pick up. It is easy to be wrong if you are not skilled. Pu Tote Bags,Tote Bag Pu,Pu Leather Tote,Pu Leather Tote Handbags GUANGZHOU KOEDS LEATHER LIMITED , https://www.kodes-bag.com
These steps tell you how to connect the computer socket