LED lights are known for their low power consumption, long life and easy control. With the development of technology, more and more families use led lights after renovation. The lamp body of the LED ceiling lamp is mounted directly on the roof and is suitable for overall lighting, usually used in the living room and bedroom. When anything is broken, how about repairing the led ceiling light? Many families have some experience in replacing lamps, but there are also some shortcomings on the emerging LED lights. Xiaobian teaches you how to install a led ceiling light . First, the installation method introduction The mask for removing the ceiling lamp before installation, there are two ways to fix the mask of the ceiling lamp, one is rotating, and the other is the buckle. Once the mask and lamp are removed, they can be installed directly, and the reserved wires are threaded into the wire holes of the base. Hold the base of the lamp with one hand and press it where it needs to be installed. Use a screwdriver to screw the screw into one of the empty positions, but do not screw it. After fixing a screw, review the installation position and adjust it appropriately. Once you are sure, screw the remaining screws. Connect the power cord to the terminal block of the fixture later. If the wall to be installed is a concrete or a hard place, the self-tapping screws will not be screwed in at all, so you need to install them with eye expansion screws. Second, the installation notes Any appliance must be turned off before installation or maintenance. Make sure that the power is off, or that the wires reserved for installation are not powered, otherwise it is not safe. The two ends of the ceiling lamp power supply connection should have good electrical contact. They should be wrapped with black rubber tape and kept at a certain distance. If possible, do not put the two wire ends under the same piece of metal to avoid short circuit. Dangerous. The insulation of the lamp cap should not be damaged or leaked to prevent electric shock when replacing the lamp. Third, led ceiling lamp repair problem The led ceiling light is not bright, it is the problem of the light source and the power supply. The light bulb is the light source, and the light bulb is replaced by a new one. The led ceiling light is illuminated and the repair has been completed. No light is a problem with the power supply or the installation process. If you use a multimeter to detect the light source is no problem, then see if it is a power problem, the general LED ceiling lamp is an external power supply method, then buy a power supply directly, some LED lamp manufacturers use the power is not good The power supply is one of the most prone to problems. The above is about how to install the LED ceiling lamp related content, I hope to be helpful to everyone! Qi installed network, China's well-known large-scale decoration platform, decoration leading brand. If you want to make a new design, you are advised to apply for the free design service of the net, and help you plan a reasonable space layout and beautiful design through the professional designer's on-site measurement room. >> Click here for professional designer free room design Disclaimer: We have used all means to find the source of the picture or content. We have not found the relevant right holder. Please ignore the negligence. If the relevant rights holders see it, please contact us in time. We will delete and proceed as soon as possible. Handle it properly. In the ESD Access Control, the Anti-static status indicator ESD tester is an important device to check from the source. status indicator ESD test host can detect whether the anti-static measures or equipment of each worker who enters the anti-static area is in place and qualified. That is to say, before the worker enters the work area, the RFID card access control system is used to confirm whether the worker can enter the work area, so as to avoid entering with a large amount of static electricity, which may cause product loss. Anti-Static Status Indicator Esd Tester,Status Indicator Esd Test Host,Rfid Card Access Control System,Status Indicator Esd Tester Guangdong Zecheng Intelligent Technology Co., Ltd , https://www.zecheng-security.com
How to install led ceiling lamp led ceiling lamp is broken how to repair