[ Chinese wardrobe net ] If the wardrobe is not well selected, it will lead to poor quality and shorten its life. It may also emit toxic gases such as formaldehyde, which will endanger the health of users. So how is the difference between the wardrobe panels determined? 1, different grades, the plates are also different. How to judge the plate of the custom closet? Generally, the cut surface of the sample is seen. From the cut surface, the blockboard is two or four layers of upper and lower boards (also thickened using four or more single boards) close to the solid wood core, the quality of the fine board. The core cut surface is flat and there is no gap; the MDF is pressed by fine fibers, the combination is relatively tight and the weight is relatively large; the particle board is a wooden granular structure, but the combination is not tight enough, the weight is light, and the quality is poor. There are small pores; the multi-layer board is made of a plurality of veneers, generally three or five layers. 2. Look for environmentally friendly panels. Professional custom wardrobe manufacturers use environmentally friendly panels that meet national testing standards, while some manufacturers use inferior panels that have no test reports and pose a potential threat to human health. Therefore, to buy a custom closet should first look at whether the business has a plate inspection report and related test certificate from the national authority inspection department. 3, the veneer looks at the quality. Some wardrobes look good on the surface, however, with a light stroke, you can draw obvious scratches. These custom-made wardrobes are made of surface-coated vellum paper or ornate paper sheets that are often used in low-cost wardrobes on the market, and have poor wear resistance. Professional custom closet manufacturers generally use environmentally friendly melamine veneer with thick thickness and high temperature and high pressure treatment, high surface strength, abrasion resistance and scratch resistance. 4, sheet metal sealing to see work. Professional custom-made wardrobe manufacturers use precision panel saws to cut sheets, and there is no chipping around the sheets. After the edges are sealed, the water in the air is effectively prevented from intruding into the interior of the board. Some manufacturers have no professional equipment, rough cutting, and obvious edge collapse around them. Some even cut corners and only cut one side of the front side of the board. The unsealed surface easily absorbs moisture from the air, causing the sheet to swell, causing the wardrobe to deform and affecting the service life. Sketching Chair Set,Sketching Chair,Sketching Chair With Tablet,Training Chair With Tablet AU-PINY FURNITURE CO., LTD , https://www.jmaupiny.com
How to choose custom wardrobe plates for custom wardrobe plates?