In the daily use of the processor, there are some common problems such as insufficient development of the printing plate. If the developer concentration is insufficient, the time for replenishing the developer is adjusted too long, and the printing plate is also insufficiently developed. If the temperature of the developer in the plate processor is too low, the flushing speed of the plate processor is too fast, the development time will be shortened, the development will be insufficient, and the plate will not be cleaned. The following solutions are proposed for these common problems. 1. Check the developer temperature and development time and adjust to reasonable data. 2. When using the developer, the manufacturer will provide the proportion of the formula, which will be done according to the ratio. But sometimes you can add some. 3, the plate machine should be repaired in time, replace the rubber roller, regularly clean the crystal in the tank and the pipe wall. The specific method is: using oxalic acid to circulate water in the plate processor and effectively remove the dirt, and the brush roller of the ps punching machine should also be cleaned, and the necessary replacement is required. 4, in the process of removing dirt, the operation is not careful, in addition to the lack of dirty liquid, in addition to the failure of the dirty injection, the use of liquid time is short, after the use of dirty liquid dry on the plate may cause the plate to be dirty. 5. In the process of sizing, a low concentration of glue is used, and oxidation of the non-image part will cause the plate to become dirty. The solution to this kind of problem is: the surface should be fully washed after being dirty, the glue concentration should be increased when the glue is applied, the glue should be evenly distributed; the cover should be tightly closed after the use of the dirty note; the plate after the glue is applied, the length of the plate is dry Then print again. Article source address: http://
PVC Coated Barbed Wire
Galvanized
Baebed Wire is made by high quality galvanized wire , it's widely used
as protecting wire fence in many fields , such as in national line ,
railway , high way , airport etc .
Anping County CQ
Wire Mesh Co.,Ltd, established in 2010, and located in the Hometown of
Wire Mesh in China, is a professional leading manufacturer engaged in
the production and sale of Gabion, Welded Wire Mesh, S.S.wire mesh etc.
Anping County CQ Wire Mesh Co., Ltd wishes to create a bright future with customers on the
base of equality and mutual benefit and sincerely welcome friends from
all over the world to visit our factory. We look forward to being of
service and offer a quality and friendliness that is synonymous with CQ
Screens.
Pvc Coated Barbed Wire,Pvc Electro Barbed Wire,Double Twisted Barbed Wire,Galvanized Pvc Coated Barbed Wire Anping Chuangqian Wire Mesh Co., Ltd , https://www.cqwiremesh.com
How to solve the common problems of the printing machine