Everyone knows that the production of wooden doors is controlled by strict technology, so what should be paid attention to during use and installation? Error-prone link 1 When transporting the wooden door, try to avoid scratching or bumping the door frame and the door leaf. When placing the door frame door fan, it is also necessary to place it on the indoor horizontal floor that is not exposed to direct sunlight but is ventilated. Remember not to place the door frame door diagonally. Error-prone link 2 The installation of the wooden door must be completed in the ground engineering of the hole (such as: floor tiles, stone), after the wall putty is scraped and polished (the wall needs to be attached to the wall brick, the hole at the stone, all must be affixed to the side of the hole), The installation steps of the wooden door can be performed. Error-prone link 3 The wooden door installation method must use the reserved hole installation method, and it is not allowed to install the side wall. Error-prone link 4 When installing the wooden door, check the wall humidity of the hole. If the wall thickness of the installation wall is <25%, the installation can be continued normally. If the wall thickness of the installation wall is >25%, the moisture-proof isolation layer should be installed on the installed wall. Error-prone link 5 If the wooden door is installed at the corner wall or the T-wall, the "fake wall" with a width of not less than 50 mm should be made on the side without the threshold before installation. Of course, the width of the false wall here can be determined according to the width of the line, avoiding the asymmetry of the door edge displayed on both sides. Error-prone link 6 If the door frame is made of high-density board material, it needs to be framed with screws when assembling the door frame; if the door frame is made of multi-layer board or solid wood board, it can be fixed by nails when assembling the door frame. Error-prone link 7 When installing the door frame, the door frame must be adjusted to the verticality to avoid damage to the door frame due to the drying and swelling of the foaming agent. Error-prone link 8 Since there may be lines on both sides of the door frame, the power operation should be carried out when installing the door frame. Error-prone link 9 When measuring the pore opening, the floor forming height and the wall thickness are confirmed according to the decoration reference line. Error-prone link 10 The size of the single-swing door, the sub-mother door and the double-seat door opening is (the thickness of the sleeve is 32mm): the door height = the door height + 40mm, the door width = the door width + 65mm. Other types of composite doors are subject to specific conditions (note: the door height refers to the net height from the groundwork that has been completed, the width of the door opening, and the thickness is also the net size). Glass Tips,Glass Filter Tips,Glass Filter Tip,Custom Glass Smoking Tips NANTONG OUFEIYA IMP& EXP CO.,LTD , https://www.nantongoufeiya.com
Install wooden doors, ten points can not be ignored